Filter
Top Products
8 Basic Operation Instructions
Removable Battery Pack www.silverstarmobility.com
Battery Pack Installation to Backpacker Series Lifts
Follow these steps to install the
battery pack to a Backpacker
Series Lift:
1. Remove the rubber caps and
nuts from the protruding bolts
on the side of the lift motor
housing. See figure 2.
2. Remove the spacer bar. See fig-
ure 2.
3. Mount the battery pack base onto
the protruding bolts and secure
into position with the nuts re-
moved earlier. See figure 2.
4. Insert the battery pack into the
battery pack base, making sure
that the connector on the bot-
tom of the battery pack aligns
and fully connects with the
mating connector inside the
battery pack base.
5. Connect the male connector of
the battery harness to the fe-
male connector at the base of
the Backpacker.
BATTERY
PACK
Figure 2. Battery Pack Installation
BATTERY
PACK BASE
LIFT MOTOR
HOUSING
6. Secure the battery harness to the other cables with wire ties.
Battery Pack Installation to SilverBoom
The base of the battery pack has 4 mounting holes (1 at each corner) for
mounting the base permanently to a vehicle. Install the base in a location
where it will not interfere with lift operation and is in close proximity to an
auxiliary outlet or cigarette lighter outlet.
WARNING! Before drilling the mounting holes in your vehicle,
make absolutely certain through a visual inspection that
there are no obstructions in the path of the drill bit, such as
the fuel tank, exhaust pipes, or electrical wires.
SPACER BAR
NUTS
BOLTS