Filter
Top Products
11
TO ADJUST DEPTH OF CUT
Loosen the depth adjusting knob (A)
Fig. 1, and raise or lower the saw
housing until the blade extends the
desired distance below the base. For
best results, the blade should barely
protrude through the workpiece. Firmly
tighten the knob to hold the saw in
position.
DISCONNECT TOOL FROM POWER SOURCE.
A
Fig. 1
TO ADJUST FOR BEVEL CUTS
Loosen the front (A) Fig. 2 and rear (B) Fig. 2 angle-adjusting knobs. Tilt the
saw housing until the desired graduation mark (C) lines up with the
indicating line (D) Fig. 3 on the depth adjusting bracket. Firmly tighten the
knobs to hold the saw in the selected position.
DISCONNECT TOOL FROM POWER SOURCE.
TO ATTACH THE BASE INSERT
The base insert is used to reduce chipping and splintering of the top fibers
of plywood and paneling when used in conjunction with a fine tooth blade.
When the base insert is used, it is not necessary to have the good or
finished side of the work down during the cutting operation.
Fig. 2
Fig. 3
A
B D
C
NOTE: Do not use this insert when making bevel cuts.