Filter
Top Products
12
Adjust the saw for the minimum depth of cut. Place the slot of the insert
around the stud (A) Fig. 4 on the front of the saw base. Install a flat washer
and thumb nut to the stud loosely. Adjust the saw for the desired depth of
cut, and align the insert so that the saw blade is centered in the slot in the
insert. Tighten the thumb nut firmly.
DISCONNECT TOOL FROM POWER SOURCE.
DO NOT use your saw if the telescoping guard is not in
working order. If telescoping guard binds or is sluggish,
return the saw to your nearest AUTHORIZED PORTER-
CABLE SERVICE STATION or PORTER-CABLE SERVICE
CENTER FOR REPAIR.
HOW TO USE THE SAW
Support the work
properly and hold the
saw firmly to prevent
loss of control which
could cause injury. See
Fig. 6 for the proper
way to hold this tool.
DISCONNECT TOOL FROM POWER SOURCE.
Fig. 4
Fig. 5
A
A
Fig. 6
TO ATTACH THE RIP GUIDE
Adjust the saw for the minimum depth of cut. Place the slot in the rip guide
over the stud (A) Fig. 5 on the front of the saw base.
Install a flat washer and thumb nut on the stud loosely. Adjust the guide to
the desired width of cut. Take into consideration the blade thickness and
set. Tighten the thumb nut firmly.