Filter
Top Products
23
Quantum Jazzy 1400 Series Rev C Feb 04 www.pridemobility.com
V. COMFORT ADJUSTMENTS
Reclining Seat
If your power chair is equipped with a reclining seat, you can adjust the
seatback angle with the seatback release lever. The lever is located on the right
side of the seat base.
To adjust the seatback angle:
1. Press down on the lever.
2. Move the seatback to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you can adjust it
to four different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws on both seat hinges. See figure 9.
2. Set the seatback at desired angle.
3. Reinstall the screws on both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrests width independently of each other.
NOTE: Changing the armrest width may increase the overall width of
your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest receiver
bracket. See figure 9.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the armrest knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nuts. See figure 9.
3. Loosen the adjusting screw. See figure 9.
4. Turn the adjusting screw clockwise to raise the front of the armrest, or turn the adjusting screw counterclockwise to lower the front
of the armrest.
5. Tighten the jam nuts to lock the adjusting screw into place.
Footrest Height
The footrest height is easily adjusted to six different heights.
To raise or lower the footrest:
1. Use a hex key to remove the bolt, spacers, and nut from the footrest. See figure 10.
2. Raise or lower the footrest to the desired height.
3. Reinstall the bolt, spacers, and nut into the footrest.
Figure 9. Seatback and Armrest
Adjustments
ADJUSTING
SCREW
ARMREST KNOB
JAM NUT
JAM NUT