Quantum 1420 Stud Sensor User Manual


 
28
www.pridemobility.com Quantum Jazzy 1400 Series Rev C Feb 04
V. COMFORT ADJUSTMENTS
Figure 19. Toggle Switch
NOTE: Be sure you are on a flat level surface before activating the power elevating seat.
Power Elevating Seat Operation
You can control the power seat through either the toggle switch located on the armrest or through your controller. For information on how
to raise and lower your power seat through your controller, see VII. Operation.
To operate the power elevating seat:
1. Push the toggle switch forward to raise the seat. See figure 19. When you release the toggle, the seat will stop. Once the seat
reaches its highest extension, the lift action stops; you should continue to hear and/or feel the lift motor running. This is
because there is a clutch mechanism that allows the motor to continue running after the lift has reached its limit. This clutch
works at both the top and bottom extensions of the lift.
CAUTION! Do not allow the motor to run more than a few seconds after the mechanism reaches the top or
bottom limit.
2. Pull the toggle switch rearward to return the seat to its lowest position. When returning to the lowest position, always be sure that the
mechanism has reached its lowest limit.
To use the swivel feature:
1. Locate the swivel lever under the seat. It is located on the opposite side of the controller.
2. Push down on the lever to rotate the seat in 90° increments.