Filter
Top Products
LABC1 • 16
ASSEMBLY INSTRUCTIONS FOR CUSTOM CASE
The enclosure is a key element to the overall pride you will have upon
completing your Ramsey kit. The enclosure will show how you were able to
“build from scratch” a commercial piece of high-tech electronics. For some of
us, the enclosure will also hide a number of “not-so-pretty” assembly
mistakes. Once the kit is enclosed, your friends will never know that you were
new to soldering. Finally, the enclosure case will protect your electronics from
many possible causes of damage so that you can receive years worth of
enjoyment using, talking about, and remembering the fun you had building
your kit. In short, TAKE YOUR TIME
when assembling the enclosure. This is
the part that you and your friends will look at and admire for years!
1. Lay the front and rear plastic plates over their corresponding labels to
verify which sticker goes with which panel. You’ll want to work with one
panel at a time to avoid possible mix-ups.
2. Remove the backing material from one of the stickers and line it up
properly on its pre-punched panel. Make sure that they are aligned
correctly before allowing them to touch the plastic plates. They stick the
first time; line them up right!
3. Use a sharp hobby knife to cut out the holes in the labels along the pre-
punched holes. A short sawing motion works well around the inner
circumference of the holes.
4. Repeat the above steps for the other panel.
5. Insert the board into the case with the knobs and LED extending
through the holes in the front panel.
6. Raise the rear portion of the PC board and extend the jacks through the
rear plastic plate. Insert the plate into the grooves on the base tray.
7. Secure the PC board to the bottom base tray with 4 short Phillips head
screws.