Filter
Top Products
3
NPK pÉÅìêÉ=tçêâ
Use clamps or a vise to hold work
when practical. It’s safer than using
your hand, frees both hands to oper-
ate tool.
NQK açåÛí=lîÉêêÉ~ÅÜ
Keep proper footing and balance at
all times.
NRK j~áåí~áå=qççäë=táíÜ=`~êÉ
Keep tools sharp and clean for best
and safest performance. Follow
instructions for lubricating and chang-
ing accessories.
NSK aáëÅçååÉÅí=qççäë
Before servicing; when changing
accessories such as blades, bits, cut-
ters, etc.
NTK qç=oÉÇìÅÉ=qÜÉ=oáëâ=lÑ=^ÅÅáÇÉåí~ä=
pí~êíáåÖ=
Make sure switch is in “OFF” position
before plugging in. Turn switch “OFF”
in the event of a power failure.
NUK rëÉ=oÉÅçããÉåÇÉÇ=^ÅÅÉëëçêáÉë
Consult the operator’s manual for rec-
ommended accessories. Follow the
instructions that accompany the
accessories. The use of improper
accessories may cause hazards.
NVK kÉîÉê=pí~åÇ=lå=qççä
Serious injury could occur if the tool is
tipped or if the cutting tool is acciden-
tally contacted.
Do not store material above or near
the tool such that it is necessary to
stand on the tool to reach them.
OMK `ÜÉÅâ=a~ã~ÖÉÇ=m~êíë
Before further use of the tool, a guard
or other part that is damaged should
be carefully checked to ensure that it
will operate properly and perform its
intended function. Check for align-
ment of moving parts, binding of mov-
ing parts, breakage of parts,
mounting, and any other conditions
that may affect its operation. A guard
or other part that is damaged should
be properly repaired or replaced. If
power cord is worn or cut, or dam-
aged in any way, have it replaced
immediately.
ONK aáêÉÅíáçå=lÑ=cÉÉÇ
Feed work into a blade or cutter
against the direction of rotation of the
blade or cutter only.
OOK kÉîÉê=iÉ~îÉ=qççä=oìååáåÖ=rå~íJ
íÉåÇÉÇK
Turn power off. Don’t leave tool until it
comes to a complete stop.