Filter
Top Products
5
UNPACKING
LOOSE PARTS
The following items are included:
n Stand Assembly (1)
n Lower Foot (1)
n Hex Bolt, 6 mm x 41 mm (2)
n Curved Washers, 6 mm (4)
n Lock Nut, 6 mm (2)
n Carriage Bolt, 1/4 in.-20 x 3 in. (4)
n Lockwasher, 1/4 in. (4)
n Wing Nut, 1/4 in. (4)
n Flat Washer, 1/4 in. (4)
n Operator's Manual (1)
NOTE: Before beginning assembly, check that all parts
are included. If you are missing any part, do not assemble
this accessory. Call 1-800-4-RIDGID or E-mail us at
info@ridgid.com to get the missing part. Sometimes small
parts can get lost in packaging material. Do not throw away
any packaging until the accessory is completely assembled
and attached to your power tool. Check packaging for
missing parts before contacting RIDGID.
STAND ASSEMBLY
HEX HEAD BOLT
LOCK NUT
CURVED WASHER
CARRIAGE BOLT
FLAT
WASHER
LOCKWASHER
WING
NUT
TOOLS NEEDED
The following tools (not included) are needed for properly assembling your workstand.
CLAW HAMMER
WRENCHES
10 mm (2)
FLAT SCREWDRIVER
DRILL
DRILL BITS (1/4 in., 3/8 in.
AND 5/8 in. WOOD BORING BIT)
LOWER FOOT
3