Filter
Top Products
10
ASSEMBLY
EXTENSION BAR(S) OPERATION
See Figures 10 and 11.
Both extension bars may be adjusted to provide maximum
workpiece support. To adjust the extension bars:
n Loosen adjustable handle by turning counter
clockwise.
NOTE: Adjustable handle can be repositioned if
necessary. Lift up on handle and rotate to desired
position then release handle.
n Slide out extension bar to desired position and tighten
extension bar handle.
Fig. 10
ADJUSTABLE
HANDLE
LOCKING PIN
KNOB
NOTE: There is a catch to limit the overall extension bar
travel.
n Pull out on locking pin knob and swing leg down until
locking pin locks leg in the down position.
n Turn foot knob counterclockwise to loosen and slide
foot extension down until foot contacts the floor. Tighten
foot knob.
n Repeat for the other extension bar.
NOTE: It may be necessary to realign roller assemblies
with the miter saw table. See Mounting and Aligning Roller
Assembly on page 9.
Fig. 11
LEG
FOOT
KNOB