Filter
Top Products
12
13
LOADING THE TOOL WITH NAILS
See Figures 6 - 7.
n Connect the tool to the air supply.
WARNING:
The tool’s driving mechanism may cycle when the
tool is first connected to the air supply. Always
connect the tool to the air supply before loading
nails to prevent injury from unintended cycling.
Always make sure the tool’s magazine is empty
at the beginning of each work session, before
connecting to an air supply.
n �Slide the pusher all the way to the rear of the magazine
until it locks into place.
WARNING:
Keep the tool pointed away from yourself and
others when loading nails. Failure to do so could
result in possible serious personal injury.
n �With the nose of the tool pointed away from you, feed
a strip of nails into the magazine. Be sure the nails are
pointed downward and at the angle shown.
n Depress the button located on the left side of the pusher
to allow the pusher to move the nails up to the driving
mechanism. The pusher will stop when it rests against
the end of the nail strip.
NOTE: Do not allow the pusher to snap back into
place.
WARNING:
Use only the nails recommended for use with this
tool (refer to the Fastener Guide). The use of any
other nails can result in tool malfunction, leading
to serious injuries.
WARNING:
Never load nails with the workpiece contact or
trigger activated. Doing so could result in possible
serious personal injury.
OPERATION
Fig. 7
Fig. 6
NAILS
PUSHER
BUTTON
BUTTON