RIDGID R2720 Sander User Manual


 
15
WARNING:
To prevent the possibility of sawdust or foreign
objects being thrown into your face and eyes,
never attempt to use the sander without dust bag
properly installed. Sawdust or foreign objects
being thrown into your face and eyes could result
in possible serious injury.
DUST BAG
See Figure 11.
The dust bag provides a dust collection system for the sander.
It should be installed over the exhaust hole located on the
side of the sander. For more efficient operation, empty dust
bag when half full.
Do not connect sander to power supply before installing
dust bag.
To install/remove dust bag:
n Unplug the sander.
n Place the opening of dust bag over exhaust hole of the
sander, aligning the notch inside opening of dust bag with
groove on exhaust hole. The bag should be installed with
the zipper down when sander is in upright position.
n Turn the dust bag counterclockwise to secure in place.
n To remove the dust bag, turn clockwise and pull off.
To empty dust bag:
Remove dust bag from sander, open zipper, and shake out
dust.
DUST BAG
DUST
EXHAUST
GROOVE
DUST BAG
OPENING
TURN TO SECURE
DUST BAG
WARNING:
Do not use the dust collection bag when sanding
metal. Using the dust collection bag when sanding
metal creates a fire hazard, which could damage
the tool and lead to serious personal injury.
WARNING:
Collected sanding dust from sanding surface
coatings such as polyurethanes, linseed oil, etc.,
can self-ignite in the sander dust collection bag
or elsewhere and cause fire. To reduce the risk
of fire, always empty the dust bag frequently
while sanding and never store or leave a sander
without totally emptying its dust bag. Also
follow the recommendations of the coatings
manufacturers.
OPERATION
Fig. 11