10
DEPTH
STOP ROD
ASSEMBLY
INSTALLING AUXILIARY HANDLE ASSEMBLY
See Figure 2.
An auxiliary handle is packed with the drill for ease of op-
eration and to help prevent loss of control.
Open the clamping ring by turning the handle counter-
clockwise.
Slide the ring of the auxiliary handle onto the spindle collar
of the drill.
Tighten the auxiliary handle at the desired angle by
turning
the handle clockwise.
NOTE: For convenience the screw has been trapped inside
the auxiliary handle.
To prevent thread damage and possible loss of control, the
auxiliary handle should be checked periodically for tightness.
Do not operate the drill with the handle loose.
INSTALLING THE DEPTH STOP ROD
See Figure 3.
Follow these steps to install the depth stop rod:
Depress the depth stop rod adjustment button.
Insert the depth stop rod as shown in figure 3.
Release the depth stop rod adjustment button.
Fig. 2
Fig. 3
DRILL BIT
TO DECREASE
DRILLING DEPTH
AUXILIARY
HANDLE ASSEMBLY
TO INCREASE
DRILLING DEPTH
DRILLING
DEPTH
AUXILIARY
HANDLE ASSEMBLY
TO TIGHTEN
TO LOOSEN
360°
ROTATION
DEPRESS HERE
TO ADJUST
DEPTH STOP ROD