Filter
Top Products
10
11
OPERATION
TO INSTALL BATTERY PACK
See Figure 4.
n Align the raised rib on the battery with the groove inside
flashlight base.
n Slide together until latches click.
CAUTION:
When placing battery pack in the worklight, be sure
raised rib on battery pack aligns with groove inside
worklight and latches snap into place properly.
Improper installation of the battery pack can cause
damage to internal components.
Fig. 4
Fig. 5
TO TURN WORKLIGHT ON/OFF
See Figure 5.
To turn worklight ON or OFF, depress switch trigger located
beneath handle.
TO CHANGE BEAM DIRECTION
See Figure 5.
Rotate worklight head up to 180˚ to change direction of
light beam.
TO ADJUST WORKLIGHT BEAM
See Figure 5.
n While holding worklight with beam pointed away from
you, secure worklight head to prevent rotation.
n With your other hand, twist beam adjustment ring clock-
wise for a wide-angle beam, or counter-clockwise for a
spot beam.
CAUTION:
Battery tools are always in operating condition.
Use caution when carrying to prevent depressing
the switch trigger when light is not needed.
TO REMOVE BATTERY PACK
n Locate latches on side of battery pack and depress to
release battery pack from worklight.
n Remove battery pack from worklight.
SWITCH
TRIGGER
ADJUSTABLE BEAM
180° ROTATING HEAD
BATTERY
WIDE-ANGLE BEAM
SPOT BEAM
RAISED
RIBS
LATCHES