Filter
Top Products
12
OPERATION
INSTALLING BATTERY PACK
See Figure 4 - 5.
n Lock the switch trigger on the drill by placing the
direction of rotation (forward-reverse) selector in center
position.
n Place battery pack in the drill. Align raised rib on battery
pack with the groove inside the drill.
n Make sure the latches on each side of your battery pack
snap in place and battery pack is secured in the drill
before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom of
the drill and latches into place properly. Improper
installation of the battery pack can cause damage
to internal components.
REMOVING BATTERY PACK
See Figure 4 - 5.
n Lock the switch trigger on the drill by placing the
direction of rotation selector in center position.
n Locate latches on side of battery pack and depress to
release battery pack from the drill.
n The battery pack will automatically disconnect in
direction to be removed when buttons are depressed.
n Remove the battery pack from the drill.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
SWITCH
See Figure 6.
To turn your drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
See Figure 6.
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
22
20
18
16
14
Fig. 6
VARIABLE SPEED
SWITCH TRIGGER
Fig. 4
FORWARD/REVERSE/LOCK OFF
SELECTOR
Fig. 5
DEPRESS LATCHES TO
RELEASE BATTERY PACK