15
OPERATION
INSTALLING DEPTH GAGE ROD
See Figure 11 - 12.
A depth gauge rod has been packed with your hammer drill
to assist you in controlling the depth of drilled holes.
When drilling holes with the depth gauge rod installed, the
desired hole depth has been reached when the end of the
rod comes in contact with the surface of the material being
drilled.
Follow these steps to install and adjust the depth gauge
rod.
n Loosen the auxiliary handle.
n Insert the depth gauge rod through hole on the auxiliary
handle.
n Adjust the depth gauge rod so that the drill bit extends
beyond the end of the rod to the required drilling depth.
n Tighten the auxiliary handle securely. This secures the
depth gauge rod at the desired depth of cut. It also se-
cures the auxiliary handle.
ADJUSTABLE TORQUE CLUTCH
This drill is equipped with an adjustable torque clutch for
driving different types of screws into different materials. The
proper setting depends on the type of material and the size
of screw you are using.
ADJUSTING TORQUE
See Figure 13.
�Identify the twenty four torque indicator settings located on
the front of the drill.
�Rotate adjusting ring to the desired setting.
• 1 - 4 For driving small screws.
• 5 -8 For driving screws into soft material.
• 9 -12 For driving screws into soft and hard
materials.
• 13 -16 For driving screws in hard wood.
• 17 - 20 For driving large screws.
• 21 - 23 ( ) For heavy drilling.
• For hammer drilling.
R
R
R
Fig. 13
TO DECREASE
TORQUE
TO INCREASE
TORQUE
ADJUSTING
RING
DRILL BIT
Fig. 12
DRILLING DEPTH
Fig. 11
TO INCREASE
DRILLING
DEPTH
TO DECREASE
DRILLING DEPTH
TO TIGHTEN
TO LOOSEN