Filter
Top Products
Operating and Maintenance Instructions
4
Connection to X-10C Chemical
Cylinder
Verify that the X-10C chemical cylinder valve is closed before
attempting to attach the X-10SW hose. Carefully attach the X-
10SW hose and verify that the connector is properly seated.
Attach the X-10SW safety chain to the hole in the X-10C pres-
sure gauge shroud. Verify that the safety on the spray wand pistol
grip has been set before proceeding. DO NOT open the X-10C
chemical cylinder valve until you are preparing to use the X-
10SW sprayer. Pressurize the sprayer by carefully opening the X-
10C chemical cylinder valve while observing the built-in pressure
gauge. CAUTION: ALWAYS point the X-10SW/X-10C connec-
tor away from you and in a safe direction before opening the X-
10C valve. The X-10C at full pressure should be between 550 psi
and 700 psi. An X-10C bottle used with the X-10SW handheld
sprayer with 250 psi showing on the gauge can still have up to
five remaining shots before refilling.
Preoperational Use
1. Try to talk inmate out of the cell.
2. Evaluate the barricade and the attitude of the inmate.
3. Decide the best location for probe insertion.
4. Assemble officers who will operate X-10SW. Position each
for best results depending on the amount of room available
on the floor or tier.
5. Inform inmate that you will be using the X-10SW and
allow the inmate to come out voluntarily.