Filter
Top Products
Operating and Maintenance Instructions
5
Operation of X-10SW Handheld
Sprayer
The X-10SW must be used in strict conformation with the
Department Operational Procedures.
1. Place the X-10C chemical cylinder in the fabric carrier.
2. Fasten the Velcro flap and hose straps so the bottle
cannot slip out of the fabric carrier.
3. Place the carrier on your back in the same manner that
you would any backpack.
4. Fasten the chest strap and arrange the hose for either
right-hand or left-hand operation as desired.
5. Verify that the spray wand pistol grip safety lever is in the
safe position before proceeding. Examine the spray wand
tip to be sure that it is properly seated in the quick release
connector. If not properly seated, the tip can be shot off
the pistol grip with the first chemical shot.
6. If you are using a “Salinas” or wide-angle fog tip, verify
that the tip is properly oriented to provide the desired
spray pattern.
NOTE: The spray tips can rotate during repeated use or close
contact, so check tip orientation before each use.
After Using or When Refilling the X-
10SW with X-10C chemical cylinder
Attached
After using the X-10SW, immediately close the X-10C chemical
cylinder valve to stop further chemical flow to the wand. After
closing the X-10C valve, the handheld wand must be sprayed in a