Ryobi 4060310 Saw User Manual


 
4
TOOLS NEEDED
Fig. 3
INSTALLING THE MITER SLOT TABLE
See Figure 3.
Turn the ON/OFF switch to the OFF position.
Unplug the saw from the switched on-board outlet.
Disconnect the saw from the power supply.
Remove the sliding miter table and accessory table
from the saw.
Place the miter slot table onto the saw as shown in
Figure 3.
WARNING:
The table saw should never be connected to a power
supply while you are assembling parts. Disconnect-
ing the table saw will prevent accidental starting that
could cause serious personal injury.
ASSEMBLY
7/16 in. NUT DRIVER
Fig. 2
3/16 in. HEX KEY
1/4-20 x 1 in.
HEX CAP SCREW
WASHER
1/4-20 NUT
SHIMS
MITER
SLOT TABLE