Ryobi BGH825 Grinder User Manual


 
Page 13
ASSEMBLY
WASHERS
HEX BOLTS
BGH615
WORK
REST
BGH625
BGH825
WORK REST – BGH615
See Figure 7a.
Mount the work rests to the inside of each wheel guard us-
ing two hex bolts (8 mm x 8) and two washers (8 mm) on
each side.
Before tightening the bolts, adjust the gap between the
grinding wheel and the work rest to a maximum of 1/16 in.
Tighten securely.
WORK REST – BGH625
See Figure 7b.
Mount the work rests to the work rest bracket using the
knob, washer, and one hex nut.
Before tightening the bolts, adjust the gap between the
grinding wheel and the work rest to a maximum of 1/16 in.
Tighten securely.
WORK REST – BGH825
See Figure 7c.
Before attempting to mount the work rest, remove the hex
nut and star washer from the phillips screw. See Figure 7c.
Place the work rest over the phillips screw before replacing the
hex nut and star washer. Using the hex bolt (5 mm x 10 mm)
and washer (5 mm), secure the work rest against the inside
of the wheel guard.
Before tightening the bolts, adjust the gap between the
grinding wheel and the work rest to a maximum of 1/16 in.
Tighten securely.
Fig. 7a
Fig. 7b
Fig. 7c
HEX
NUT
WASHER
WORK
REST
HEX NUT
STAR
WASHER
WORK
REST
WASHER
HEX BOLT
WORK REST
BRACKET
PHILLIPS
SCREW
KNOB