Filter
Top Products
Page 15
45
0
DUST NOZZLE (MODEL CSB 130JS)
See Figure 22.
A dust nozzle is included with saw Model CSB130JS. As
shown in figure 22, the dust nozzle fits over the dust chute
which is located on the rear of the upper blade guard.
Attach dust nozzle with a twisting motion. The easy rotation
of the dust nozzle allows the operator to direct the flow of
dust and chips. The dust and chip opening
should always
be turned away from the operator.
TO POCKET CUT
See Figure 23.
WARNING:
Always adjust bevel setting to zero before making a
pocket cut. Attempting a pocket cut at any other setting
can result in loss of control of your saw possibly causing
serious injury.
Adjust the bevel setting to zero, set blade to correct blade
depth setting, and swing the lower blade guard up using the
lower blade guard handle. ALWAYS RAISE THE LOWER
BLADE GUARD WITH THE HANDLE TO AVOID SERIOUS
INJURY. While holding lower blade guard by the handle,
firmly rest the front of the base flat against the workpiece
with the rear of the handle raised so the blade does not
touch the work.
See Figure 23.
Depress the switch trigger.
ALWAYS LET THE BLADE REACH FULL SPEED, THEN
SLOWLY LOWER BLADE INTO THE WORK UNTIL BASE
IS FLAT AGAINST WORK. After you complete your cut,
release the trigger and allow the blade to come to a complete
stop. After the blade has stopped, remove it from the work.
Then, corners may be cleared out with a hand saw or sabre
saw.
WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious injury.
WARNING:
Do not use this product as a component of other products.
Also, do not use attachments or accessories not
recommended for use with this product. Any such use
could result in possible serious personal injury.
OPERATION
DUST
NOZZLE
Fig. 22
Fig. 23
DUST
CHUTE
UPPER
BLADE GUARD
MODEL CSB130JS
LOWER BLADE
GUARD
POCKET CUT
LOWER BLADE
GUARD HANDLE