Filter
Top Products
11
BLADE
WRENCH
BLADE
SCREW
SPINDLE LOCK
BUTTON
Fig. 4
SPINDLE
BLADE
SCREW
SPRING
WASHER
OUTER
WASHER
(“D”
WASHER)
BLADE
INNER
FLANGE
BUSHING
ASSEMBLY
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of the
saw. Also, never use a blade that is too thick to allow
outer blade washer to engage with the flat on the spindle.
Larger blades will come in contact with the blade guards,
while thicker blades will prevent blade screw from se-
curing blade on spindle. Either of these situations could
result in a serious accident.
CAUTION:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
ATTACHING BLADE
See Figures 2 - 4.
Unplug the saw.
Depress and hold spindle lock button.
Remove blade screw by turning it counterclockwise with
the blade wrench, while keeping the spindle lock button
depressed.
Remove spring washer and outer blade washer (“D”
washer).
Wipe a drop of oil onto the inner flange bushing and outer
blade washer (“D” washer) where they contact blade.
WARNING:
If inner flange bushing has been removed, replace it
before placing blade on spindle. Failure to do so will
prevent blade from tightening properly and could result
in serious personal injury.
Retract the lower blade guard into the upper blade guard
using the lower blade guard handle. Make sure the lower
guard spring works properly, allowing the guard to move
freely.
Check to see that the saw teeth and arrow on the saw
blade and the arrow on the upper guard are pointing in
the same direction.
NOTE: The saw teeth point upward at the front of the
saw as shown.
Fit the saw blade inside the lower blade guard and onto
the spindle.
Replace “D” washer.
Replace spring washer with cupped side against “D”
washer.
Depress spindle lock button and replace blade screw.
Tighten blade screw securely by turning it clockwise with
the blade wrench.
Fig. 2
Fig. 3
OUTER WASHER
(“D” WASHER)
CUPPED SIDE OF
SPRING WASHER
OUTSIDE OF SPRING
WASHER
NOTE: Never use a blade that is too thick to allow the
“D” washer to engage with the flat on the spindle.
ARROW
ON UPPER
GUARD
TO
LOOSEN
TO
TIGHTEN