Filter
Top Products
19
OPERATION
OPTIONAL EDGE GUIDE
See Figure 23.
Use the optional edge guide, part no. 969862009, when
making long or wide rip cuts with the saw.
To assemble edge guide:
Unplug the saw.
Place edge guide through holes in base as shown in the
figure.
Adjust edge guide to the width needed.
Tighten edge guide lock knob securely.
To use edge guide:
Secure the workpiece.
Position the face of the edge guide firmly against the edge
of workpiece.
Guide the saw along the edge to achieve a straight rip
cut.
NOTE:
The guiding edge of the workpiece must be straight
for the cut to be straight. Use caution to prevent the blade
from binding in the cut.
OPTIONAL DUST NOZZLE KIT
See Figure 24.
You may purchase a dust nozzle kit, part no. 200673001, for
use with the saw. The adaptor fits over the dust chute which
is located on the upper blade guard. The nozzle attaches to
the adaptor.
NOTE: If you use the nozzle, you should always connect it
to a standard vacuum hose.
To attach dust nozzle:
Unplug the saw.
Lift lower blade guard.
Orient adaptor to fit into the dust chute opening on upper
blade guard.
Secure adaptor with screw provided.
Align hole in nozzle with raised lip on adaptor and snap
into place when using a vacuum hose.
Fig. 24
ADAPTOR
RAISED
LIP
SCREW
NOZZLE
HOLE
DUST
CHUTE
Fig. 23
EDGE GUIDE
EDGE GUIDE
LOCK
KNOB