Filter
Top Products
11
CAUTION:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
ATTACHING BLADE
See Figures 2 - 3.
Unplug the saw.
Depress and hold spindle lock.
Remove blade screw by turning it counterclockwise with
the provided wrench, while keeping the spindle lock
depressed.
Remove spring washer and outer blade washer (“D”
washer).
WARNING:
If inner flange bushing has been removed, replace it
before placing blade on spindle. Failure to do so could
cause an accident since blade will not tighten properly.
Retract the lower blade guard into the upper blade guard
using the lower blade guard handle. Make sure the lower
guard spring works properly, allowing the guard to move
freely.
Check to see that the saw teeth and arrow on the saw
blade and the arrow on the lower guard are pointing in
the same direction.
NOTE: The saw teeth point upward at the front of the
saw as shown.
Fit the saw blade inside the lower blade guard and onto
the spindle.
Reinstall “D” washer.
Reinstall spring washer.
Depress and hold spindle lock and replace blade
screw.
Tighten blade screw securely by turning it clockwise with
the wrench.
NOTE: Never use a blade that is too thick to allow the
“D” washer to engage with the flat on the spindle.
REMOVING BLADE
See Figure 4.
Unplug the saw.
Depress and hold spindle lock.
Remove blade screw by turning it counterclockwise with
the provided wrench, while keeping the spindle lock
depressed.
Remove spring washer and outer blade washer (“D”
washer).
Lift lower blade guard.
Remove blade.
ASSEMBLY
Fig. 4
WRENCH
BLADE
SCREW
SPINDLE LOCK
BUTTON
Fig. 2
SPINDLE
BLADE
SCREW
SPRING
WASHER
OUTER BLADE
WASHER (“D”
WASHER)
BLADE
INNER
FLANGE
BUSHING
Fig. 3
OUTER BLADE WASHER
(“D” WASHER)
CUPPED SIDE OF
SPRING WASHER
OUTSIDE OF SPRING
WASHER