Filter
Top Products
20
DANGER:
DO NOT point the laser at yourself or others. Class IIIa
lasers will burn the retinas and could cause serious injury
to the eyes.
WARNING:
Before performing any adjustment, make sure the tool
is unplugged from the power supply and the switch is in
the OFF ( O ) position. Failure to heed this warning could
result in serious personal injury.
WARNING:
Use of controls or adjustments or performance other
than those specified herein could result in hazardous
radiation exposure.
ADJUSTING THE LASER
See Figure 23.
� Unplug the circular saw.
� Make sure laser is turned off.
Remove the laser cover by lifting it off its base.
� Turn laser on.
� Loosen the screw inside laser.
� Rest the front of the base on scrap workpiece.
Adjust the laser beam with the mark on the scrap
workpiece by loosening the screw to the laser aperture
and slowly moving laser guide left or right.
Since blade thicknesses vary, always make a trial cut in
scrap workpiece to ensure an accurate cut.
� Once alignment is achieved tighten the screw.
� Replace the laser cover.
Check for proper alignment.
� Repeat as necessary until laser is aligned.
ADJUSTMENTS
LASER
COVER
SCREW
Fig. 23