Filter
Top Products
Page 7
14
14
16
16
18
18
20
20
OPERATION
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could result
in objects being thrown into your eyes, resulting in possible
serious injury.
CHARGING YOUR SCREWDRIVER
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (driving screws followed
by recharging) for them to become fully charged.
If the charger does not charge your screwdriver under
normal circumstances, return both the screwdriver and
charger to your nearest Ryobi Authorized Service Center
for electrical check.
TO CHARGE
See Figure 2.
■ Insert charger plug into input jack making sure they are
properly connected.
■ Charger can be used with normal household voltage
of 120 volts, 60 Hz, AC only.
■ Connect charger to power supply.
■ After normal usage, 3 hours or less of charging time is
required to fully recharge batteries. Note: If batteries
are completely discharged, 6 hours or longer of charging
time is required to fully recharge batteries.
■ Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
COLLET
The collet on your screwdriver has been designed to accept
1/4 in. hex bits.
See Figure 3.
TO INSERT BIT
See Figure 3.
Insert bit into collet as far as possible.
Note: One bit is packed with your screwdriver.
Fig. 2
Fig. 3
COLLET
BIT
1
4
1
6
1
8
22
CHARGER
CHARGER PLUG
INPUT
JACK