Filter
Top Products
Page 8
CHARGING YOUR DRILL-DRIVER
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to become fully charged.
TO CHARGE MODEL HP62
■ Charge only with the charger provided.
■ Connect charger to the tool by inserting charger plug
into input jack. Note: As shown in figure 2, input jack is
located at rear of tool.
■ Make sure power supply is normal household volt-
age, 120 volts, 60 Hz, AC only.
■ Connect charger to power supply.
TO CHARGE MODEL HP722
■ Charge only with the charger provided.
■ Connect charger to the battery pack by inserting charger
plug into input jack. Note: As shown in figure 3, input
jack is located at rear of battery pack.
Note: Battery pack for Model HP722, can be removed
from the drill to be charged.
See Figure 3.
To remove
battery pack from drill, follow instructions on page 9.
■ Make sure power supply is normal household volt-
age, 120 volts, 60 Hz, AC only.
■ Connect charger to power supply.
MODEL HP62 AND HP722
■ The charge indicator light (LED) indicator, which is
located on rear of drill, will light up when charger is
properly connected to power supply. This red light indi-
cates your battery is charging and will remain on until
charger is disconnected from power supply.
Note: During the two year warranty period on drill
Model HP722, if the charge indicator light (LED) fails to
come on or goes out while charging battery pack, re-
turn charger and battery pack to your nearest autho-
rized service center for repair or replacing. If you have
drill Model HP62, return charger to service center.
■ After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: If battery
pack is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery
pack.
■ The charger housing and the tool handle will become
slightly warm to the touch while charging. This is nor-
mal and does not indicate a problem.
■ DO NOT operate drill while it is connected to the charger.
The driving ability will not increase.
■ DO NOT place charger in an area of extreme heat or
cold. It works best at normal room temperature.
■ When battery pack has been charged, disconnect
charger from power supply. This practice will increase
battery life.
OPERATION
Fig. 2
CHARGER
CHARGE
INDICATOR
LIGHT (LED)
CHARGER
PLUG
INPUT
JACK
MODEL HP62
MODEL HP722
Fig. 3
CHARGER
CHARGE
INDICATOR
LIGHT (LED)
INPUT
JACK
CHARGER
PLUG
CHARGE
INDICATOR
LIGHT (LED)
CHARGER
BATTERY
PACK
INPUT
JACK
BATTERY
PACK