Filter
Top Products
Page 6
SPECIFICATIONS:
HP721 HP961 HP1201
Chuck 3/8 in. Keyless 3/8 in. Keyless 3/8 in. Keyless
Motor DC Motor 7.2V DC Motor 9.6V DC Motor 12.0V
Switch Two-Speed Variable Speed Variable Speed
No Load Speed 330/500 RPM 0 - 550 RPM 0 - 550 RPM
Clutch 24 Positions 24 Positions 24 Positions
Charger Input 120V, 60 Hz, AC Only 120V, 60 Hz, AC Only 120V, 60 Hz, AC Only
Charge Rate 3-6 Hours 3-6 Hours 3-6 Hours
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger/charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charger/charging assembly to your nearest Ryobi
Authorized Service Center for electrical check.
DISPOSAL OF THE EXHAUSTED BATTERY
To preserve natural resources, please
recycle or dispose of properly.
This product contains nickel-cadmium
battery. Local, state, or federal laws may
prohibit disposal of Nickel-Cadmium
batteries in ordinary trash. Consult your
local waste authority for information
regarding available recycling and/or
disposal options.
For more information on battery recycling
call 1-800-8 BATTERY.
BATTERY PACK PREPARATION FOR
RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Also, never touch both terminals with metal
objects and/or body parts, as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
WARNING:
Do not attempt to disassemble the battery pack. Fire or injury may result.
R
E
C
Y
C
L
E
1
.
8
0
0
.
8
2
2
.
8
8
3
7
RBRC
Ni
Cd
The operation of any power tool can result in foreign objects being thrown into your
eyes, which can result in severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and a full face shield
when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields.
WARNING: