Filter
Top Products
12
OPERATION
Fig. 6
STAPLES
Fig. 5
LATCH
LOADING THE TOOL WITH STAPLES
See Figures 5 and 6.
n Remove battery pack from the tool.
n Hold tool upside down; squeeze latch and slide base
open.
n Place staples in channel, legs facing upward and close
base.
n Make sure the latch is securely locked in place.
n Reattach battery pack to tool.
LOADING THE TOOL WITH BRADS
See Figures 5 and 7.
n Remove battery pack from the tool.
n Hold tool upside down; squeeze latch and slide base
open.
n Place brads in the center of the channel with "T" head
sitting on the slot base. Close base while making sure
brad strip stays upright in channel.
NOTE: There are two channels for the brads. Use the
smaller channel for brads sized 3/4 in. to 1 in. Use the
larger channel for brads sized 1-1/4 in. Refer to molding
on the tool.
n Make sure that the latch is securely locked in place.
n Reattach battery pack to tool.
BRADS
Fig. 7
3/4 IN. TO 1 IN.
1-1/4 IN.