Filter
Top Products
12 13
MAINTENANCE
BULB REPLACEMENT
See Figure 6.
When purchasing replacement bulb, request recommended
part number 7817502.
TO REPLACE BULB:
n Allow bulb to cool.
�n Remove battery pack by depressing side latches to re-
lease from worklight.
�n Remove lens cover by turning in a counterclockwise
direction.
�n Remove old bulb from spring by pulling out.
��n Insert new bulb in spring and push in slightly to seat.
��n Replace lens cover.
��n Replace battery pack.
NOTE: For your convenience, the worklight has a spare bulb
storage area located behind the lens cover.
Fig. 6
BULB
BULB
STORAGE AREA
LENS COVER
WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields when using compressed air to clean worklights.
If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the worklight when cleaning or per-
forming any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at a Ryobi Authorized Service Center.