Ryobi TR30 Laminate Trimmer User Manual


 
Page 12
ACCESSORIES
Standard accessories included with your laminate trimmer
are two wrenches and a 1/2 in. (13 mm) diameter flush trim
bit.
The following is a list of optional accessories available for
your TR30 Laminate Trimmer:
Part No. Description
6072373 Trimmer Guide
4675208 Straight Trim Bit
6072063 Straight Guide
HELPFUL HINTS
Always clamp workpiece securely before trimming.
A safe operator is one who thinks ahead.
Always wear eye protection when trimming.
Make setup adjustments carefully. Then double check.
Measure twice and cut once.
Keep cutters clean and properly sharpened.
Don’t let familiarity make you careless.
Study all safety rules and do the job safely.
NEVER place your hands in jeopardy.
Make certain clamps can’t loosen while in use.
Test difficult setups on scrap — Don’t waste lumber.
Plan each operation before you begin.
Provide for smoother operation by cleaning your
trimmer frequently. Shake trimmer or blow with an air
jet to remove sawdust buildup.
THINK SAFETY BY THINKING AHEAD.
Fig. 10
WARNING:
Avoid hand positions that may expose fingers to cutter
through open areas of trimmer base.
See Figure 11.
Fig. 11
EDGE SHAPING WITH OPTIONAL TRIMMER GUIDE