Filter
Top Products
Page 12
3
0
4
5
1
5
2
2
.
5
3
1
.
6
2
0
15
30
5
2
2
.
5
3
1
.
6
2
ASSEMBLY
WARNING:
To prevent accidental starting that could cause possible
serious personal injury, assemble all parts, make sure all
adjustments are complete, and make sure all fasteners
are secure before connecting saw to power supply. Saw
should never be connected to power supply when you are
assembling parts, making adjustments, installing or re-
moving blades, or when not in use.
MITER LOCK HANDLE
See Figure 7.
To install the miter lock handle, place the threaded stud on
the end of the miter lock handle into the threaded hole in
the control arm under miter table. Turn clockwise to tighten.
DUST GUIDE
See Figure 8.
To install the dust guide, place the end over the exhaust
port in the upper blade guard. Turn the guide so that the
open end is facing down.
DUST BAG
See Figure 9.
A dust bag is provided for use on your miter saw. It fits over
the exhaust port on the upper blade guard. To install it,
remove dust guide from exhaust port. Then, squeeze the two
metal clips to open the mouth of the bag and slide it on the
exhaust port. Release the clips. The metal ring in the bag
should lock in between the grooves on the exhaust port.
To remove the dust bag for emptying, simply reverse the
above procedure.
WORK CLAMP
See Figure 10.
To install work clamp, place the shaft of the clamp in either
hole in front of the miter table base. Rotate the knob on the
clamp to move it in or out as needed.
WARNING:
When using the work clamp with the stop block, install the
clamp on the stop block side of the blade. This will
eliminate the possibility of the saw catching the loose end
and kicking up. Failure to heed this warning can result in
serious personal injury.
UPPER
BLADE GUARD
Fig. 8
CONTROL
ARM
TO
LOOSEN
MITER
LOCK HANDLE
MITER
TABLE
EXHAUST
PORT
DUST GUIDE
TO
TIGHTEN
Fig. 10
MITER
TABLE BASE
WORK CLAMP
Fig.7
4
5
30
1
5
0
1
5
31.62
22
.5
22.5
0
15
30
45
DUST BAG
EXHAUST
PORT
Fig. 9