Filter
Top Products
Page 17
1
5
30
5
2
2
.
5
31.62
4
5
30
1
5
0
15
30
4
5
3
1
.
6
2
2
2
.5
31.62
2
2
.5
45
30
15
0
15
3
0
45
3
1
.
6
2
2
2
.
5
3
1
.6
2
22.5
4
5
30
1
5
0
15
30
45
3
1
.6
2
22.5
3
1
.6
2
22.5
ADJUSTMENTS
SQUARING THE SAW BLADE TO THE FENCE
See Figures 21 - 24
■ Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental
starting causing possible serious personal injury.
■ Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
■ Loosen the miter lock handle approximately one-half
turn.
■ Depress the miter lock plate and rotate the miter table
until the pointer on the control arm is positioned at 0
°
.
■ Release the miter lock plate and securely tighten the
miter lock handle.
■ Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Slide the other leg of
the square against the flat part of saw blade.
Note: Make sure that the square contacts the flat part of
the saw blade, not the blade teeth.
■ The edge of the square and the saw blade should be
parallel as shown in figure 21.
■ If the front or back edge of the saw blade angles away
from the square as shown in figures 22 and 23, adjust-
ments are needed.
■ Loosen the socket head screws that secure the mount-
ing bracket to the miter table.
See Figure 24.
■ Rotate the mounting bracket left or right until the saw
blade is parallel with the square.
■ Retighten the screws securely and recheck the blade-
to-fence alignment.
MITER
TABLE
BLADE
MITER
LOCK HANDLE
Fig. 21
MITER
TABLE
VIEW OF BLADE
SQUARE WITH FENCE
BLADE
MITER
FENCE
MITER
LOCK
PLATE
FRAMING
SQUARE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
FRAMING
SQUARE
MITER
FENCE
Fig. 22
MITER
FENCE
Fig. 23
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
FRAMING
SQUARE
MITER
TABLE
BLADE
SOCKET
HEAD SCREWS
Fig. 24
MITER
TABLE
MOUNTING
BRACKET