Filter
Top Products
assembly
7,
The Front Charmer should be slightly lower than the
top of the Vertical Channels. Check the height with a
combination square as shown. If it is higher, loosen the
Flange Nuts and lower it.
TOOL HOLDER
1. Screw a 1-3/4 inch tong socket head screw tightly into
each Knob asshown.
/
SET SCREW WRENCH
/
/
DOTS
2. Screw a Square Nut onto each of the Follower Pins.
NOTE: The Nut has four clots on one side., .they must
face the threaded end.