Filter
Top Products
• 3 •
PREPARING TO CHARGE3.
If it is necessary to remove the battery from the vehicle to charge it, al-3.1
ways remove the grounded terminal from the battery rst. Make sure all of
the accessories in the vehicle are off, so as not to cause an arc.
Be sure the area around the battery is well ventilated while the battery is 3.2
being charged.
Clean the battery terminals. Be careful to keep corrosion from coming into 3.3
contact with your eyes.
Add distilled water to each cell until the battery acid reaches the level 3.4
specied by the battery manufacturer. Do not overll. For a battery without
removable cell caps, such as valve regulated lead-acid batteries, carefully
follow the manufacturer’s recharging instructions.
Study all of the battery manufacturer’s specic precautions while charging 3.5
and recommended rates of charge.
Determine the voltage of the battery by referring to the vehicle owner’s 3.6
manual and make sure that the output voltage selector switch is set to the
correct voltage. If the charger has an adjustable charge rate, charge the
battery at the lowest rate rst.
CHARGER LOCATION4.
Locate the charger as far away from the battery as the DC cables permit.4.1
Never place the charger directly above the battery being charged; gases 4.2
from the battery will corrode and damage the charger.
Never allow battery acid to drip onto the charger when reading the electro-4.3
lyte specic gravity or lling the battery.
Do not operate the charger in a closed-in area or restrict the ventilation in 4.4
any way.
Do not set a battery on top of the charger.4.5
DC CONNECTION PRECAUTIONS5.
Connect and disconnect the DC output clips only after setting all of the 5.1
charger switches to the “off” position and removing the AC plug from the
electrical outlet. Never allow the clips to touch each other.
Attach the clips to the battery and chassis, as indicated in steps 6.5, 6.6, 5.2
and 7.2 thru 7.4.