Filter
Top Products
11
Using the Set 830-TV
Using the Set 830-TV
To switch the Set 830-TV system on, proceed as follows:
Switching the transmitter on/off
To switch the transmitter on:
̈ Switch your sound source on.
The transmitter automatically switches on. The operation
indicator
8 lights up green.
If the transmitter doesn’t switch on:
̈ Read the chapter “If a problem occurs ...” on page 21.
To switch the transmitter off:
̈ Switch your sound source off.
The transmitter automatically switches off after
3 minutes. The operation indicator
8 goes off.
To disconnect the transmitter from the mains:
̈ Pull out the mains connector from the wall socket.
Note:
When not using the transmitter for extended periods of
time (e.g. when you are on holiday), pull out the mains
connector from the wall socket. In this case, however, the
receiver’s rechargeable battery will not be recharged.
Sequence of steps Page
1. Switch your sound source (e.g. TV) on. The
transmitter automatically switches on.
11
2. Adjust the volume on the receiver to a low level. 12,13
3.
Put the stethoset receiver on. The receiver
automatically switches on
.
12
4. Adjust the desired volume on the receiver. 13