Filter
Top Products
-20-
Df[\cD('00D]^J`eZ\/&'.
FG<I8K@FEJ
KX`cjkfZb
The tailstock (=`^li\(,) can be used to support
workpieces with a live or dead center. The lathe can drill
or bore holes in the center of a part with a drill bit held
by the tailstock. The tailstock can also be offset for cut-
ting shallow tapers.
Kflj\k_\kX`cjkfZb#[fk_\j\jk\gj1
(% Slide the tailstock to the desired position.
)% Tighten the tailstock lock nut to lock the tailstock in
place on the ways.
*% Loosen the quill lock lever to unlock the quill.
+% Turn the quill feed handwheel clockwise to move
the quill towards the spindle or counterclockwise to
move away from the spindle.
,% Tighten the quill lock lever to lock the quill in place.
Kfj\klgk_\kX`cjkfZb]fi[i`cc`e^#[fk_\j\jk\gj1
(% With the tailstock locknut tight, unlock the quill lock
lever.
)% Turn the quill feed handwheel clockwise to extend
the quill about one inch.
*% Insert the MT#3 arbor and chuck or an MT#3 tapered
drill shank into the quill until the taper is firmly
seated.
+% Turn the quill feed handwheel clockwise to feed the
drill bit into the rotating workpiece.
,% To remove the chuck and arbor, turn the quill feed
handle counterclockwise until the chuck is pushed
out of the tailstock taper.
;i`cc`e^N`k_k_\KX`cjkfZb
=`^li\(,% Tailstock and quill lock handles
in locked position.
Quill Lock Lever
Offset
Adjustment
Offset
Scale
Tailstock
Lock Nut