Filter
Top Products
OPERATION
-24-
Figure 43. Table height handwheel.
Figure 44. Depth scale indicates depth of cut.
Figure 45. Conveyor speed control dial adjusts
conveyor feed rate.
Always wear a dust mask
safety glasses, and hearing
protection when operating
the sander. Sawdust may
cause allergic reactions or
respiratory problems.
Make sure loose clothing
and long hair is secured
and kept away from all
moving parts.
DO NOT operate this
sander until you have
completed all assembly
and adjustments. Observe
all safety precautions,
and read and understand
this entire manual.
Basic Sanding
The normal sanding depth for most workpieces is
1
⁄64". This depth can be achieved by
approximately a
3
⁄4 turn of the table height
handwheel. For each turn of the handwheel, the
conveyor table moves approximately 0.021" See
Figure 43.
Remember, heavy cuts and/or a feed rate that is
too fast can jam or burn the workpiece, instantly
burn the sandpaper, slip the drive belts and give
poor sanding results. See Figures 44 and 45.
To help prevent these conditions, make the
correct depth of cut; and for wide workpieces,
sand them two or three times without adjusting
the table height. Also, turn the stock 180° to
ensure an even cut.
TIP: When you sand dark-colored wood and then
you sand light-colored wood, pass a PRO-STIK
®
15" x 20" cleaning pad through the drum sander so
the light-colored wood will not become stained
from the previously sanded dark wood.
INSTRUCTION MANUAL
MODEL W1678
26" DOUBLE DRUM SANDER
Phone: 1-360-734-3482 • On-Line Technical Support: tech-support@shopfox.biz
COPYRIGHT © MARCH, 2003 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in Taiwan