Filter
Top Products
Model W1774 18 Gauge Brad Nailer
-10-
A jammed nail must be cleared before
using the nailer again.
To clear a jammed nail from the dis-
charge area, do these steps:
1. DISCONNECT NAILER FROM THE AIR
SUPPLY!
2. Depress the magazine latch and pull
back the magazine cover until it
stops.
3. Remove the nail stick from the
magazine.
4. Remove the two cap screws and
driver guide cover from the nose
assembly (see Figure 5).
Clearing Jammed Nails
5. The jammed nail should now be
visible; remove it with needle nose
pliers.
6. Throw the damaged nail away and
insert a new nail stick that only
contains clean, undamaged nails. DO
NOT use dirty or damaged nails!
7. Re-install the guide cover with the
two cap screws, push the magazine
cover all the way forward, and
check the operation of the safety
nose mechanism (refer to Page 7 for
detailed instructions),
Figure 5. Removing guide cover.