Filter
Top Products
Model W1775 Nailer/Stapler Kit
-5-
The Model W1775 is designed to be
operated at 60-100 PSI using clean,
dry, regulated, compressed air. Do not
exceed the 120 PSI maximum operating
pressure for your model.
Before using your new nailer/stapler,
regulate the air pressure to find the
optimum setting within the specified
operating range. Start by testing the
nailer/stapler at a low setting, then
increase the air pressure as needed for
satisfactory results.
An in-line filter/lubricator/regulator unit
can be installed as depicted in Figure 1.
This filter/lubricator/regulator unit
will protect your tool from damaging
water build-up, allow you to adjust and
maintain regulated air pressure to your
tool, and save you the inconvenience of
having to manually lubricate your tool
every time you use it.
If you plan on installing a filter/
lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Figure 1. Typical filter/lubricator/regulator installation order.
Compressed Air System
Exceeding the maximum permissible
operating pressure may damage
the nailer/stapler and cause it to
malfunction. To protect yourself
from personal injury, DO NOT
allow the air pressure to exceed
the recommended pressure for this
nailer/stapler!