Filter
Top Products
Model W1780 1
1
⁄4" Brad Nailer
-10-
A jammed nail must be cleared before
using the nailer again.
To clear a jammed nail from the dis-
charge area, do these steps:
1. DISCONNECT NAILER FROM THE AIR
SUPPLY!
2. Pull back and latch the magazine
pusher.
3. Remove the nail stick from the
magazine.
4. Open the nailer nose by removing the
rubber nose tip, squeezing the nose
release mechanism (Figure 6), and
opening the nose cover.
Clearing Jammed Nails
5. Dislodge the jammed nail with a
tool that will fit in the slot on the
underside of the nose.
6. Throw the damaged nail away and
insert a new nail stick that only
contains clean, undamaged nails. DO
NOT use dirty or damaged nails!
7. Close the nose cover and re-install
the nose tip.
8. Release the catch lever and let
the pusher slide to the front of the
magazine.
Figure 6. Nose opened to clear a jam.
Nose Cover
Nose Release
Nose
Tip