Filter
Top Products
Model W1795/W1801 Deluxe Spray Gun
-6-
Assembly
Figure 3. Installing filter.
2.
Screw the cup onto the top of the
body.
3. Install the barbed hose fitting into
the base of the gun handle and tight-
en in place with the lock nut.
4. Secure the air hose to the barbed fit-
ting with a hose clamp.
Note: Using a
1
⁄4" NPS quick discon-
nect set-up (not included), will make
operation and maintenance tasks eas-
ier.
5. Attach the spray gun to an air hose
regulated between 43.5 and 58 PSI.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other
possible contaminant.
1. Insert the filter into the gun body
(see Figure
3).
1. Fluid Control: Controls the volume
of material that travels through the
fluid tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a
wide fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun.
4. Atomizing Cap
: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
6. Material Cup: Holds the paint to be
sprayed.
Controls
Figure 4. Controls.
Cup
Fluid Control
Pattern
Control
Atomizing Cap
Trigger
Air Flow Control