Filter
Top Products
-24-
W1808/W1809/W1810 Cyclone Dust Collectors
SET UP
Figure 29. Attaching foam tape to
collector drum lid.
20. Check to see if 10 x 50mm foam tape is pre-installed
on the collector drum lid. If tape is not attached,
install it as shown in
Figure 29, and trim to length
with a sharp knife, if necessary.
21. Attach the casters to the bottom of the lower collec-
tion drum, as shown in
Figure 30, using (4)
3
/8"-16
hex nuts, (8)
3
/8" flat washers, and (4)
3
/8" lock wash-
ers.
Note: The Model W1808 collection drum comes as a
preassembled unit. The upper and lower collection
drums on the Model W1809/W1810 require assembly
(see Step 22).
22. Model W1809 & W1810 Only: Connect the upper and
lower collection drums and secure with the included
metal clamp and bolt, as shown in
Figure 31.
Figure 31. (Top) Connecting upper and
lower collection drums, (bottom) drum
clamp installed between drums
.
Figure 30. Casters attached to the lower
collection drum.