Filter
Top Products
Handle Adjustments
6
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Filters
Your Simplicity vacuum cleaner is equipped with a secondary filter and a post filter.
These filters capture fine dust particles and protect the motor from dirt. It is important
to change the filters regularly — approximately once a year, or as needed.
To Change the Secondary Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover and the bag.
2. Remove the secondary filter and replace with a new filter (Fig. 5).
3. Replace the bag and bag compartment cover.
NOTE: Filters cannot be washed and used again.
To Change the Post Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover.
2. Remove the foam filter from the front of the bag compartment (Fig. 6).
3. DO NOT THROW AWAY THE FILTER HOLDER.
4. Insert a new filter into the holder and replace the bag compartment cover.
Fig. 5
Edge Cleaning Feature
The edge cleaning feature provides improved cleaning of carpets near walls and stationary furniture. For maximum edge
cleaning, use the left side of the vacuum near walls or stationary furniture.
Fig. 6
The handle on this vacuum cleaner can be set to one of three positions – upright, middle or low.
How to Adjust the Handle
1. To release the handle, step on the pedal at the left rear corner of the
vacuum cleaner (Fig.1).
2. Upright position – for when cleaning tools are being used or for storage (Fig 2).
Handle locks in this position.
3. Middle position – for normal cleaning (Fig. 3).
4. Low position – for cleaning under furniture (Fig. 4).
*Once in the middle postion, press the release pedal again to place the
vacuum to the low position.