Siren Players SFGH-100 Work Light User Manual


 
3
HDLPS & ALT LTS In the ALT LTS. (Down) position the grille or other lights are flashing. In the HDLPS &
ALT LTS (Up) position the headlights are also flashing. When the flasher is in the
ALT. LTS. or OFF position the Headlights will function normally. When the Headlights
are flashing, using the bright lights will override the flashers operation. An indicator
above the switch shows when either flasher is on.
RADIO Provides radio rebroadcast through the SFGH-100 siren speaker. Rebroadcast
volume is controlled by the P.A. Volume Control, and should always be set to its’
lowest position then advanced to a comfortable level. 2-way radio volume
should be set at approximately 1/3 to avoid overdriving the amplifier and
causing distortion.
NOTE: The amplifier is ON in this position and drawing current.
STBY Standby position of the siren system. All functions are ready. Switch should
normally be in this position.
WAIL Provides a slow, continuous rising & falling sound.
YELP Provides a fast, continuous rising & falling sound.
P.A. VOLUME Provides volume control of the Public Address system and radio rebroadcast.
Keying the P.A. microphone overrides all siren functions, allowing its’ operation
while the siren is in the WAIL or YELP modes.
AIR HORN Pressing this button provides a simulated air horn sound. AIR HORN overrides
all siren functions and the P.A. system.
If there are any questions concerning the installation or operation of the SFGH-100 system, please call
the factory and service center at (847) 459-1460 or Outside Illinois (800) 504-1460 and we will be happy
to assist you.
CONTROL HEAD (FIG. 4)
Radio Rebroadcast Input
Microphone jack