Filter
Top Products
BATTERY REMOVAL INSTRUCTIONS
Run motor until battery is
completely discharged before
attempting to remove battery from your tool.
1. Loosen the nut with a large wrench in direction
of arrow (A) and completely unthread nut.
2. Remove head assembly and nut from the tool.
3. Pull and remove metal front end in direction
of arrow (B) to expose and remove the two T6
torx head screws.
4. Remove the six (6) housing screws with a flat
blade screwdriver.
5. Remove housing cover by lifting upward from
front end of tool.
6. Remove lead wires from switch.
7. Wrap heavy insulating tape around battery
terminals or enclose in a sealable plastic bag to
prevent possible shorting.
8. Dispose of battery through your local waste
removal authority or a Skil Service Center.
-7-
Do not attempt to disas-
semble the battery or
remove any component projecting from the
battery terminals.
Fire or injury may result. Prior to
disposal, protect exposed terminals with heavy
insulating tape to prevent shorting.
LITHIUM-ION BATTERIES
If equipped with a lithium-ion battery, the battery
must be collected, recycled or disposed of in
an environmentally sound manner.
“The EPA certified RBRC
Battery Recycling Seal on the
lithium-ion (Li-ion) battery
indicates Robert Bosch Tool
Corporation is voluntarily
participating in an industry
program to collect and recycle these batteries
at the end of their useful life, when taken out
of service in the United States or Canada. The
RBRC program provides a convenient
alterative to placing used Li-ion batteries into
the trash or the municipal waste stream, which
may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation’s involvement in this program is
part of our commitment to preserving our
environment and conserving our natural
resources.”
!
WARNING
Battery Disposal
BATTERY REMOVAL INSTRUCTIONS
Run motor until battery is
completely discharged before
attempting to remove battery from your tool.
1. Remove the seven (7) housing screws with
a flat blade screwdriver.
2. Remove housing cover by lifting upward
from front end of tool.
3. Disconnect lead wires from switch.
4. Wrap heavy insulating tape around battery
terminals or enclose in a sealable plastic bag
to prevent possible shorting.
5. Dispose of battery through your local
waste removal authority or a Skil Service
Center.
Battery Disposal – 2362
Battery Disposal – 2372
HEAD ASSEMBLY
NUT
METAL FRONT END
T6 TORX HEAD
SCREW
ARROW (A)
ARROW (B)
FIG. 2
!
CAUTION
!
CAUTION
SM 1619X03291 05-08 5/28/08 1:52 PM Page 7