Filter
Top Products
BLADE STORAGE COMPARTMENT
Your tool is equipped with a blade storage
compartment (Fig. 6) on the backside of your
saw. To remove, push down on tab and slide
in direction of arrow. Be sure storage
compartment is closed to prevent blades from
falling out.
1. Securely clamp the work.
2. Mark the line of cut and grasp the tool with
one hand on the handle and the other
placed on the insulated rubber boot over
the front housing.
Always hold the saw by the
insulated boot on the front
housing. If you saw into a blind area where
live wiring exists, you may be shocked or
electrocuted.
3. Keep the saw footplate firmly against the
work to minimize counter-force (jumping)
and vibration.
4. Squeeze the trigger to start the tool. Let the
saw reach full speed before starting the cut.
Guide the saw so that the blade will move
along the marked line.
SAWING TIPS
Following a few simple tips will reduce the
wear on the workpiece, the tool and the
operator.
1. Blades cut on the draw or back stroke. On
fine work, such as paneling, fiberglass, etc.,
place the good side of workpiece facing
down.
2.
Use the correct saw blade for the material
being cut and keep extra blades on hand to
use when others become dull. Replace
cracked or bent blades immediately.
3. Select the footplate projection settings, as
well as the appropriate cutting speed.
4. To reduce the risk of injury, be sure the
blade always extends beyond the footplate
and work throughout the stroke. Blades
FOOTPLATE ADJUSTMENT
The footplate tilts in order to keep as much of
i
ts surface in contact with the work surface
F
ig. 4 . To adjust, hold saw firmly and pivot
footplate to desired position.
T
he footplate can also be locked at desired
d
epths to optimize blade life and/or to limit
blade protrusion beyond the end of the
footplate when cutting into large diameter pipe
or into walls.
To adjust the footplate position depth, simply
loosen the two screws in insulated rubber boot
with wrench provided, slide and move the
f
ootplate to the desired position and securely
t
ighten the screw with the wrench provided
(Fig. 5).
Using the Saw
!
WARNING
FIG. 6
BLADE
STORAGE
TAB
BLADE STORAGE
COMPARTMENT
-8-
FOOTPLATE
FIG. 4
FIG. 5
SM 2610001755 07-08 7/14/08 9:41 AM Page 8