Filter
Top Products
Discharge Tube Installation
Landlord/1700 Series (Mfg. No. 1692095)
1.
Install the spring clip (D, figure 18) with two 10-32 x
i/2
truss head screws (E), four flat washers (F), and
two locknuts (G).
2. Install
l/4-20
x
5/8
carriage bolt (H) through hole in
turbo housing. Secure with
l/4-20
flange locknut (I).
3. Position the lower tube (C) onto turbo housing and
hook inside spring clip onto flange locknut (I,
installed in step 2). Mark hole location on opposite
side of turbo housing for outer spring clip.
4. Remove lower tube and drill 9/32 hole in turbo
hous-
ing and install
l/4-20
x 5/8 carriage bolt (H) through
hole. Secure with
l/4-20
flange locknut (1).
5. Assemble the upper tube (A) onto middle tube (B) as
shown in figure 2 with two 1032
x
l/2
truss head
screws (E), four flat washers (F), and two locknuts
63.
6. Install two
lo-32 x l/2 truss head screws (E), four
flat washers (F), and two locknuts (G) to the top
holes in the lower tube (C). Leave hardware loose.
7. Install upper tubes (A and B) to lower tube (C) and
tighten hardware.
8. Install tube assembly into cart sleeve and onto turbo
housing. Hook spring clips (D) onto flange locknuts
(I)
installed on turbo housing.
“2.347
Figure 18
A. Upper Tube
B. Middle Tube
C.
Lower Tube
D. Spring Clip
E.
Truss Head Screw,
lo-32
x
l/2
F. Washer
G. Locknut, 10-32
H. Carriage Bolt, 1/4-20x
518
I. flange Locknut, l/4-20