Filter
Top Products
-24-
For Machines Mfg. Since 3/11
Turn-Nado
®
EVS Lathes
PREPARATION
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Main Inventory 1 (Figure 11) Qty
A. Steady Rest Assembly (Installed) .................1
B. 14" Faceplate w/D1-8 Camlock Stud Set ......1
C. 3-Jaw Chuck Key (Clamped on Lathe) .........1
D. Model SB1232 14" 4-Jaw Chuck
w/Combo Jaws ...............................................1
E. 4-Jaw Chuck Key ...........................................1
F. Tool Post T-Wrench (Clamped on Lathe)......1
G. Follow Rest Assembly (Installed) ..................1
Tool Box Inventory (Figure 12) Qty
H. Tool Box ..........................................................1
I. Open End Wrench 22/24mm .........................1
J. Open End Wrench 14/17mm .........................1
K. Open End Wrench 10/12mm .........................1
L. Combination Wrench 27mm ..........................1
M. Phillips Screwdriver #2 .................................1
N. Standard Screwdriver #2 ...............................1
O. Carbide-Tipped Dead Center MT#5 ..............1
P. Dead Center MT#5 .........................................1
Q . Tapered Spindle Sleeve MT#7-#5 .................1
R. Carriage Handwheel Handle .........................1
S. Cross Slide Handwheel Handle .....................1
T. Hex Wrench Set 1.5-10mm ............................1
U. Hex Wrench 10mm ........................................1
V. Cast Iron Feet ................................................8
Installed & Not Shown Qty
s 3"*AW#HUCK ..............................1
s 3"
1
⁄2" Back Plate for SB1312 ............1
Note: Some inventory components or additional
documentation may be shipped inside of the
lathe electrical cabinet. These items MUST be
removed before connecting the lathe to the power
source.
Figure 11. Main inventory.
A
B
C
D
E
F
G
Figure 12. Toolbox inventory.
R
M
N
H
J
L
T
S
U
V
I
K
Q
P
O