Filter
Top Products
-8-
For Machines Mfg. Since 3/11
EVS Toolroom Lathe w/DRO
INTRODUCTION
Foot Brake
This lathe is equipped with a foot brake (see
Figure 9) to quickly stop the spindle instead of
allowing it to coast to a stop on its own. Pressing
the foot brake while the spindle is ON also cuts
power to the motor.
After the foot brake is used, the spindle ON/
OFF lever must be returned to the OFF (middle)
position to reset the spindle switches before
spindle rotation can be re-started.
Figure 8. Tailstock controls.
AG
AH
AI
AG. Tailstock Clamp Bolt: Adjusts the clamping
pressure applied by the tailstock lock lever.
AH. Offset Scale: Indicates the relative distance
of tailstock offset from the spindle centerline.
AI. Offset Lock Bolt: Clamps together the upper
and lower halves of the tailstock after the
offset is adjusted.
AJ. Tailstock Stop Pin: Prevents the tailstock
from sliding off of the ways.
AJ
Figure 9. Foot brake and spindle ON/OFF lever.
Foot Brake
Spindle ON/OFF Lever