Filter
Top Products
EP30200 / EP30250 User Manual ◄ 5
Tool operators and maintenance personnel must always
comply with the safety precautions given in this manual
and on the stickers and tags attached to the tool and
hose.
These safety precautions are given for your safety. Re-
view them carefully before operating the tool and before
performing general maintenance or repairs.
Supervising personnel should develop additional pre-
cautions relating to the specic work area and local
safety regulations. If so, place the added precautions in
the space provided in this manual.
This tool will provide safe and dependable service if
operated in accordance with the instructions given in
this manual. Read and understand this manual and any
stickers and tags attached to the tool before operation.
Failure to do so could result in personal injury or equip-
ment damage.
• Operator must start in a work area without bystanders.
The operator must be familiar with all prohibited work
areas such as excessive slopes, dangerous terrain con-
ditions, and rail trafc.
• Establish a training program for all operators to ensure
safe operation.
• Do not operate the tool unless thoroughly trained or
under the supervision of an instructor.
• Always wear safety equipment such as goggles, ear,
head protection, and respiratory protection at all times
when operating the tool.
• Do not inspect or clean the tool while the battery power
source is connected. Accidental arcing can cause seri-
ous injury.
• Do not load brazing pins or ceramic rings while the bat-
tery power source is connected. Accidental arcing can
cause serious injury.
• Do not use the tool while it is connected to a battery
charger.
• Ensure battery charging is only done in a dry environ-
ment. Charging batteries in the rain or near standing
water presents an electrocution hazard. Read the safe-
ty and operation instructions provided with the battery
charger before using the battery charger.
• Do not operate a damaged, improperly adjusted, or in-
completely assembled tools.
• To avoid personal injury or equipment damage, all tool
repair, maintenance and service must only be performed
by authorized and properly trained personnel.
• Do not exceed the rated limits of the tool or use the tool
for applications beyond its design capacity.
• Always keep critical tool markings, such as labels and
warning stickers legible.
• Always replace parts with replacement parts recom-
mended by Stanley Hydraulic Tools.
SAFETY PRECAUTIONS